AUDIOLINE POWER PMR 40 Manual de usuario descargar pdf (Pagina 18)

A.W. Communication Systems Limited

TRip2 Manual, Version 1.5 Page 18 of 34 © AWCSL 2010

4.8.8. Alarm Notification Using Email

The TRip2 also includes an SMTP client for the purpose of transmitting alarm status messages via

email.

Most parameters of the email message are configurable to allow maximum flexibility, but the

subject and message body of an email sent when an alarm set will be:

Subject: [Unit Name] Trip2 [Alarm Name] alarm set

Body: [Unit Name] The [Alarm Name] has been set on this Trip2 unit

Where [Unit Name] will be replaced with the unit’s configured name (with the unit set name

command) and [Alarm Name] is the name of the alarm – either RTP, RTCP or LCP.

The subject and message body of an email sent when an alarm is cleared will be:

Subject: [Unit Name] Trip2 [Alarm Name] alarm cleared

Body: [Unit Name] The [Alarm Name] has been cleared on this Trip2 unit

The use of a suitable email-to-SMS gateway application will allow the signalling of alarm conditions

to mobile telephones via SMS messages.

4.9. Patching

Note: Patching functionality is only available for TRip2 version 1.0.27 and later. Please follow the

TRip2 update procedure if you need to upgrade to a newer version.

The TRip2 can be configured to use a patching mode, which allows two radio sites to enable/disable

talkthrough. This can be triggered by the value of a logic pin or in response to a selcall message at

either site, and patching activation/deactivation can be monitored via a generated selcall message or

a logic output.

When patching is activated, logic packets (containing, for example, COR and PTT logic levels) will be

passed between the TRip2 units as usual, allowing one site’s COR to trigger the other site’s PTT and

vice-versa. When patching is deactivated, logic packets will still be sent as a “keep-alive” measure,

but logic levels will be ignored, meaning a COR at one site no longer triggers PTT at the other.

Although selcall and logic pin monitoring/responses can be used together, the following two sections

describe them independently.

4.9.1. Patching Using Selcall

For patching to be triggered via selcall messages, an “on” and “off” selcall message must be set on

both TRip2 units, and this must be the same for each unit. When the TRip2 units see the selcall “on”

message, patching will be activated. It will then be deactivated when the selcall “off” message is

received. Additionally, a timeout of between 5 and 500 seconds can be set, after which patching will

be deactivated.

The TRip2 units can also be configured to generate selcall strings when patching is activated or

deactivated. The patching deactivated selcall string will be sent whether patching mode has been

deactivated by an incoming “off” message or a timeout.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Sin comentarios

AUDIOLINE POWER PMR 40 Manual de usuario Pagina 18