AUDIOLINE POWER PMR 40 Instrucciones de operaciones descargar pdf (Pagina 22)

- Operation -

3.3 Calling another subscriber

When you want to talk to other subscribers, proceed as follows: The

two radios must be switched on and set to the same channel.

To speak, press the PUSH TO TALK button on the left-hand side.

Hold the unit about 5 cm from your mouth and speak in a normal

voice. When you have finished, release the PUSH TO TALK button.

The person you are speaking to will hear a signal tone (Roger beep)

when you release the TALK button. This will indicate to the other

subscriber that you have finished speaking and are waiting for a reply.

Note: While you are holding the PUSH TO TALK button, you

will not be able to hear any incoming calls. As is usual with

radio units, only one of the two participants in the call can

speak at any one time.

Therefore, always wait until you hear the signal tone (Roger beep)

before pressing the PUSH TO TALK button again.

While you are pressing the PUSH TO TALK button, the

symbol

will appear in the display. When you receive a call, the

symbol will

appear in the display.

Volume adjustment

The volume of the incoming call signal depends on your volume

setting. Eight volume levels can be set using the

and  buttons.

Transmitting a call signal

Press the PUSH TO TALK button and press the

 button once. A

ringing tone will sound on the called unit for two seconds.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Sin comentarios

AUDIOLINE POWER PMR 40 Instrucciones de operaciones Pagina 22